Behringer DSP1400P User Manual download pdf (Page 9)

The mains connection of the ULTRAMIZERPRO is made by using the supplied cable. It meets all of the

international safety certification requirements. Please make sure that all units have a proper ground connec-

tion.

+ Before you connect your ULTRAMIZERPRO to the mains, please make sure that your local

voltage matches the voltage required by the unit (see chapter 5.2 for details)!

As a standard the audio inputs and outputs on the BEHRINGER ULTRAMIZERPRO are fully balanced. If

possible, connect the unit to other devices in a balanced configuration to allow for maximum interference

immunity. The automatic servo function detects unbalanced connections and compensates the level differ-

ence automatically (6dB correction).

The MIDI links (IN/OUT/THRU) are made over standardized DIN patch cords. The data communication is

isolated from ground by an opto-coupler.

1.3 Control elements

Fig. 1.1: ULTRAMIZERPRO front panel

The BEHRINGER ULTRAMIZERPRO is equipped with ten illuminated parameter keys, one jog wheel (rotary

control), a numeric display, 8 LED indicators and a power switch. Each of the two fully independent channels

can be monitored with four 8-stage LED meters, displaying input level, output level and gain reduction for both

bands.

1.3.1 Front panel

Fig. 1.2: Display section DSP1400P

The two LED chains read the input signal level indB, referenced to the internal digital maximum.

+ Please note that the nominal level of the ULTRAMIZERPRO can be selected with the

+4dBu/-10dBV switch located on the back panel. (see 3.1 Level setting)

The gain reduction meters show the applied gain reduction. Gain reduction is shown for both fre-

quency bands. GRLO shows the gain reduction in the lower and GRHI in the higher frequency band.

These two OUTLED chains read the output signal level indB, referenced to the maximum output level

of +15dBu.

After power-up, the LED display reads the number of the preset last used. This clearly legible, 2½ digit

numeric display has plus/minus indicators to show that parameters are being incremented or

decremented in Edit mode.

1. INTRODUCTION

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

No comments

Behringer DSP1400P User Manual Page 9