Behringer FCA202 Quick Start Guide download pdf (Page 11)

20 21F-CONTROL AUDIO FCA202 Quick Start Guide

(1) You can connect standard commercial

headphones tted with a ¼" TRS jack

plug to the socket.

(2) Use the LEVEL control to adjust the

headphone volume. Turn the control

fully to the left before you connect

the headphones. This helps you avoid

the damage that is caused by high

volumesettings.

(3) The POWER LED indicates that the

equipment is ready to operate. It lights

up as soon as the FCA202 is provided

with power from the mains adapter or

via the FireWire socket.

(4) The FW LED lights up as soon as the

FCA202 is correctly connected by a

FireWire cable to a computer that is

in operation. If the LED does not light

up, check the FireWire connection to

thecomputer.

(5) Use the DC IN socket to connect the

mains adapter provided.

(6) The LOCK port in combination with a

suitable security lock from Kensington

oers you a very good way to protect

your equipment against theft. For further

information, visit kensington.com.

(7) Make the connection to your computer

using one of the two 6-pin FIREWIRE

sockets. You can run other FireWire

devices such as hard drives, fromthe

second socket. This means that you

always have a free FireWire port

available, even if your computer has only

one FireWire socket.

(8) You can connect balanced or unbalanced

audio cables with ¼" jack plugs to the

BAL / UNBAL OUT sockets.

F-CONTROL AUDIO FCA202 Controls

(EN) Controls

(9) You can connect unbalanced

audio cables with ¼" TS jack plugs to

theUNBAL IN sockets.

(10) The ABOUT section gives information

about the driver versions that are used.

Compare the version numbers given here

with the drivers available via Internet

from behringer.com. If you have any

problems, you should always try to

install the newest driver software.

(11) Use the LATENCY SELECT slider to set

the desired latency. Click the APPLY

button to accept the selection made.

(12) The SAMPLING FREQUENCY selection

menu allows you to set the sample rate

for the digital converter. The available

frequencies are 44.1 kHz, 48.0 kHz and

96.0 kHz.

(13) The wiring diagram is provided as

additional information. It shows the

signal ow in the FCA202.

Check Out behringer.com for

Full Manual

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Comments to this Manuals

No comments