Behringer BXL1800A User Manual download pdf (Page 8)

ULTRABASS BXL450/BXL900/BXL1800/BXL3000

5. INSTALLATION

If you want the bass signal to go through a PA system during live

gigs, you would normally need a DI box. (DI boxes process the

signals for long cables and provide a higher output level at the

mixing console). The ULTRABASS amps have a DI box already

built in! Connect the balanced DI OUT directly to the mixing console

input or to the multi-core cable leading to the console. Use a

microphone cable (2-core shielded cable with XLR connectors).

Alternatively, you can use the LINE OUT (¼" TS jack) for short

cables and mixing consoles with line-level inputs (e.g. for

recording in your home studio without having to use a

microphone). Of course, you can also use this output as an

additional send path or to connect a tuner.

4.3 The ULTRABASS as a slave with an

external pre-amp

If you wish to use another bass preamp or modeling amp

(e. g. BASS V-AMP or BASS V-AMP PRO), you can connect this

amp to the FX INSERT RETURN jack. In this configuration, the

ULTRABASS is used as a power amp only, and the two input

channels are disabled.

5. INSTALLATION

5.1 Audio connections

Except for the headphones output, all ¼" jacks on the

BEHRINGER ULTRABASS are ¼" TS connectors. The DI output

is on a balanced XLR connector. The CD inputs are on RCA

connectors.

+ Please keep in mind that your ULTRABASS should

be installed and operated only by those who possess

sufficient technical knowledge about its installation

and operation. Everyone dealing with your

ULTRABASS should be sufficiently grounded both

during the installation as well as during actual usage.

Failure to do so may cause undesirable or faulty

operation due to electromagnetic discharges, etc.

Fig. 5.1: XLR connections

Fig. 5.2: ¼" TS connector

Fig. 5.3: ¼" stereo TRS connector for PHONES

1 2 3 4 5 6 7 8 9 10

No comments

Behringer BXL1800A User Manual Page 8