Behringer MiniFBQ FBQ800 User Manual download pdf (Page 6)

MINIFBQ FBQ800

2. CONTROL ELEMENTS

1.1.2 Initial operation

Please make sure the unit is provided with sufficient ventilation, and never place the FBQ800 on top

of an amplifier or in the vicinity of a heater to avoid the risk of overheating. To power the FBQ800,

use only the power supply unit that is delivered with your equipment.

1.1.3 Online registration

Please do remember to register your new BEHRINGER equipment right after your purchase by

visiting www.behringer.com (alternatively www.behringer.de) and kindly read the terms and conditions

of our warranty carefully.

Should your BEHRINGER product malfunction, our goal is to have it repaired as quickly as possible.

To arrange for warranty service, please contact the retailer from whom the equipment was purchased.

Should your BEHRINGER dealer not be located in your vicinity, you may directly contact one of our

subsidiaries. Corresponding contact information is included in the original equipment packaging

(Global Contact Information/European Contact Information). Should your country not be listed, please

contact the distributor nearest you. A list of distributors can be found in the support area of our

website (www.behringer.com/support).

Registering your purchase and equipment with us helps us process your repair claims quicker and

more efficiently.

Thank you for your cooperation!

2. CONTROL ELEMENTS

This chapter introduces the FBQ800 and provides what you need to know about:

V using the FBQ800 (section 2.2 Front panel)

V setting up the FBQ800 (section 2.3 Rear panel)

 Ensure that only qualified personnel set up and operate the FBQ800.

2.1 About the FBQ800

The FBQ800 is a graphic equalizer that you use to modify the strength and quality of audio signals.

More specifically, you can use the FBQ800 to:

V homogenize audio signals

V correct audio signals

V filter low-frequency audio signals (feedback, floor rumble, room resonance, and mains hum)

Input sources

The FBQ800 can receive signals from studio or Hi-Fi units. Some examples of these units include

mixers, soundcards, CD-players, and signal processors.

In this documentation, the signals that the FBQ800 receives are referred to as input signals. Audio

units that send input signals to the FBQ800 are referred to as input sources.

Output targets

The FBQ800 can send signals to studio or Hi-Fi units. Some examples of these units include mixers,

soundcards, and power amplifiers.

In this documentation, the signals that the FBQ800 sends are referred to as output signals. Audio

units that receive output signals from the FBQ800 are referred to as output targets.

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

No comments

Behringer MiniFBQ FBQ800 User Manual Page 6