Behringer BTR2000 User Manual download pdf (Page 14)

RACKTUNER BTR2000

Acoustic indicator

The selected tempo is also output at the SOUND or MAIN connector.

+ If your instrument is plugged into INPUT 1, the metronome click is output only through the

SOUND connector. If it is plugged into INPUT 2, and the SOUND output is not in use, the

metronome click is output together with the instrument signal from the MAIN connector.

You can change the volume of the click at any time and thus control the volume ratio between

instrument and click if you are listening to both using one amp.

1. Briefly press the SOUND/METRONOME button. The SOUND LED above the button lights up.

2. With the wheel you can adjust the volume of the click with 12 volume levels.

+ Even at the lowest volume level (1), the metronome click is still audible. The click can be

shut off with the MUTE button.

3. If the volume is not changed for some time or if the SOUND/METRONOME button is pressed

again, the SOUND light goes out.

The metronome can naturally be muted without affecting the visual display.

1. Press the MUTE/LIGHT button.

2. The metronome click is muted and no longer output through the MAIN connector.

6. USING A FOOTSWITCH

Single footswitches can be plugged into the MUTE and SELECT connectors (not included).

+ Use only non-latching footswitches! The BEHRINGER DUAL A/B SWITCH AB200 is ideally

suited.

The following functions are available with the footswitch:

TUNER METRONOME

MUTE

To mute

MAIN output

To mute

MAIN output

SELECT

Toggle between INPUT1

and INPUT2/MIC inputs

Activate/deactivate

metronome

0RGH

6ZLWFK

Table 6.1: Options overview

If you have a double footswitch such as the BEHRINGER FS112, it must be connected to the SELECT

connector! Both functions (MUTE and SELECT) are then transmitted over a stereo connection and

can be controlled using the two buttons.

6. USING A FOOTSWITCH

1 2 ... 9 10 11 12 13 14 15 16 17 18

No comments

Behringer BTR2000 User Manual Page 14