Behringer BTR2000 User Manual download pdf (Page 16)

RACKTUNER BTR2000

8. INSTALLATION

8.1 Rack installation

The BTR2000 requires one height unit (1 HU) for installation in a 19" rack. Be certain to leave an

additional 10cm free in the back for the connectors. For installation in a rack, M6 machine screws and

nuts should be used.

Ensure a sufficient air supply and to not place your BTR2000 on an end, for example, to prevent the

unit from overheating.

8.2 Audio inputs and outputs

All audio inputs and outputs on the BEHRINGER BTR2000 are laid out as mono TS connectors.

Fig. 8.1: 1/4" TS connector

8.3 Footswitch wiring

If a double footswitch is plugged into the SELECT connector on the back of the BTR2000, the MUTE

function is transmitted on the ring and SELECT is transmitted on the tip.

Fig. 8.2: 1/4" TRS connector plug of a double footswitch

+ Always make sure that only technically qualified people install and operate your

RACKTUNER. During and after the installation, all those handling the equipment need to be

sufficiently grounded in order to avoid the potentially damaging electrostatic discharge or

similar damage that could have a permanent adverse effect on your equipment.

8. INSTALLATION

1 2 ... 11 12 13 14 15 16 17 18

No comments

Behringer BTR2000 User Manual Page 16