Behringer UB2222FX-PRO User Manual download pdf (Page 14)

EURORACK UB1622FX-PRO/UB1832FX-PRO/UB2222FX-PRO/UB2442FX-PRO

6. INSTALLATION

6.1 Rack mounting

The packaging of your mixing console contains two 19" rack

mounts for installation on the side panels of the console.

Before you can attach the rack mounts to the mixing console,

you need to remove the screws holding the left and right side

panels. Then, use these screws to fasten the two rack mounts,

each specifically to one side. With the rack mounts installed, you

can mount the mixing console in a commercially available 19"

rack. Be sure to allow for proper air flow around the unit, and do

not place the mixing console close to radiators or power amps,

so as to avoid overheating.

+ Only use the screws holding the mixing console

side panels to fasten the 19" rack mounts.

6.2 Cable connections

You will need a large number of cables for the various

connections of the console. The illustrations below show the

wiring of these cables. Be sure to use only high-grade cables.

Fig. 6.1: Foot switch connector

6.2.1 Audio connections

Please use commercial RCA cables to wire the 2-track inputs

and outputs.

You can, of course, also connect unbalanced devices to the

balanced input/outputs. Use either mono plugs, or use stereo

plugs to link the ring and shaft (or pins 1 & 3 in the case of XLR

connectors).

Fig. 6.2: XLR connections

+ Caution! You must never use unbalanced XLR

connectors (PIN 1 and 3 connected) at the MIC input

jacks if you want to use the phantom power supply.

Fig. 6.3: 1/4" mono plug

Fig. 6.4: 1/4" stereo plug

Fig. 6.5: Insert send/return stereo plug

Fig. 6.6: Stereo plug for headphones connection

6. INSTALLATION

1 2 ... 9 10 11 12 13 14 15 16

No comments

Behringer UB2222FX-PRO User Manual Page 14